DetCord – 1 lb Antweight Combat Robot


My 2018 competitor, with a titanium horizontal blade from FingerTech Robotics. I felt like rebuilding a drum spinner twice is too boring so gotta change up the weapon choice every year.

I was the winner of that fight because of the driving I did after my blade broke off. My radio is a FrSky Taranis Q X7 and it has adjustable curves for everything, so I actually had better driving control, better than most other competitors.

The steel shaft of the motor is the problem, apparently a hollow steel shaft isn’t hard enough to handle the impacts. The next video shows the second time the motor shaft broke. I did actually stick a #4-40 steel bolt into the hollow part, it may have made the problem worse, this time instead of just the shaft snapping, the entire plate holding the bearing shattered.


RoboGames 2018

Just dumping media here



Major Components:

  • Banebots T40 wheels and hubs (possibly replaced by custom molded wheels soon)
  • Pololu micro metal gearbox motors (Sanyo style), 6V HPCB, 75:1 gear ratio
  • Fingertech tinyESCs for drive
  • EMAX 30A brushless BLheli_S Bullet ESC
  • EMAX RS2205-S brushless motor with steel shaft
  • Fingertech titanium weapon blade, 6 inch long, 3/16 inch thick
  • FrSky XMR receiver
  • Delrin/Acetal top and bottom plates, laser cut
  • 3D printed body using NylonX (chopped carbon fiber infused nylon)
  • Battery is 2S1P LiPo 20C about 800mAH (advertised as 1000mAH but I don’t trust them)

Leave a Reply

Your email address will not be published. Required fields are marked *